Chapter 3 Detailed Operating Instructions
30
To recharge the batteries, set the batteries into the VersaPak
charger. The supplied charger accepts one or two batteries. A full
charge takes about 9 hours. An indicator lamp shows that the
battery is properly charging and it will remain on as long as there is
a battery in the charger. Continuous charging is not a safety
concern.
Viewing Information with the IAQ Monitor
You can view various types of information on the IAQ Monitor's
display. The information displayed will vary depending to your
instrument’s setup. The following example assumes the following:
a) Full statistics mode.
b) Toxic sensor is installed and enabled
c) Instrument Mode: Data Logging
To scroll through the different screens, follow these steps:
1. Turn the IAQ Monitor on. It will display the Main Screen,
which shows present readings of the CO
2
, temperature and
relative humidity channels with the recording status (recording
or not recording). This screen is displayed in the following
format:
N CO2 800 PPM
R.H. 48.9 %
TEMP 75.9 degF
DEW PT 46.7 degF
NOTE: The Main Screen is always displayed, even if you are not
recording on one or more of these channels.
2. Press the UP ARROW button. The IAQ Monitor will scroll to
the following screen, which gives you access to the
programming menu:
Press RECORD
For Function Menu
t/u To Continue
To Next Page
Loading...