Chapter 3 Detailed Operating Instructions
16
NOTE: The Main Screen is always displayed, even if you are not
recording on one or more of these channels.
2. Press the ON/OFF button again. The IAQ Monitor will responds
with the following:
Press RECORD
To Turn Off
ON/OFF to Continue
3. Press the Record button to turn the unit off. This is done to
prevent accidental turn off of the unit.
IMPORTANT: The IAQ Monitor cannot
be turned off while it is
recording. If you press the On/Off button while recording is in
progress, the following message will be displayed:
Cannot Turn Off
While Recording
This is done to prevent you from accidentally interrupting a test.
See "Start and Stop Recording" later in this chapter for details.
If you have not yet used Quest Suite Professional to program the
IAQ Monitor, you will see the following message when the IAQ
Monitor is turned on:
Time And Date
Not Programmed
This indicates that the real time clock has not been set with the
correct time, and all data recorded will be incorrectly time stamped.
The current date and time is automatically set from your computer's
clock when programming the IAQ Monitor with Quest Suite
Professional. See the on-line help in Quest Suite Professional for
more details.
To Next Page
Loading...
Need help?
General