OPERATING YOUR RECEIVER
13
When a source is selected, the source name will be
shown on the display.
Example:
Press DVD to select DVD as the source to the
amplifier.
NOTE:
1) Your receiver has a built in tuner. Just connect the
appropriate antenna on the back of the receiver
and you will be able to listen to radio stations. (See
details in Tuner section).
2) Other sources can be connected to the above
standard source.
Example:
You can connect an LD into the DVD inputs.
3) Refer to the “Connecting to Audio-Visual
Components” section for details on connection.
USING THE RECEIVER TO PLAY A SOURCE
After having properly connected a source (DVD,
CD, VCR) to the receiver, you can partly control
them through the receiver.
Playing a DVD with the receiver
1) Connect a DVD player to the receiver (see
connecting your receiver for details).
NOTE:
To play Dolby Digital sound, the source must be
Dolby Digital encoded and connected to the
receiver via the optical or coaxial terminal (see
“Digital Connection” on page 5 for details).
2) Press STANDBY/ON to switch on the receiver.
3) Select the DVD source by pressing the DVD
source button.
4) Switch on the DVD player and start playback.
5) Switch on your TV.
6) Select the appropriate A/V channel on the TV
(refer to your TV manual for details) until the image
from the DVD player is displayed.
7) Set the sound mode if needed (see “Advanced
sound control” on page 17 for details).
ATTENTION: If you connect the DVD and Receiver with ANALOG
signal (RCA cord). Please make sure to turn on ANALOG output in
your DVD player.
Example 1:
To play 5.1 Dolby Digital surround sound press the
Surr. mode button until “Dolby Digital” appears on
the display and all of the speakers icons light up.
Example 2:
DVD: You may also need to select the Dolby Digital
5.1 on the DVD disc menu to have the digital
surround enabled providing that the disc is
encoded with Dolby Digital 5.1 (please refer to the
DVD player and DVD disc instruction.)
ATTENTION: To play Dolby Digital, you must connect the DVD and
the receiver with DIGITAL signal (Coaxial or Optical). Not ANALOG
(RCA cord).
Example 3:
LD: You may need to select a different Audio
Channel on your LD (refer to your LD player
manual.)
8) Adjust volume knob accordingly.
To Next Page
Loading...
Need help?
General