OPERATING YOUR RECEIVER
14
OPERATING THE RADIO
The receiver has a built-in tuner that allows for
AM/FM radio function.
Manual Tuning
1) Connect the FM and AM antenna accordingly
(See “Connecting the Antennas” section on page 5
for details).
2) Press STANDBY/ON to switch on the receiver.
3) Press FM/AM or press TUNER on the remote.
4) To select band, press the FM/AM button or press
TUNER on the remote again to toggle between
FM/AM mode.
When an FM station broadcast stereo sound,
STEREO is displayed.
5) Tune the stations by pressing TUNING UP
or TUNING DOWN repeatedly until the desired
station is found. Alternatively, you can press
and hold TUNING UP or TUNING DOWN
for about one second to activate the automatic
SEARCH function. In this mode the receiver
will automatically tune frequencies until it finds a
station.
6) Repeat steps 4 & 5 to tune another radio station.
Select sound effects if needed by pressing PRESET
EQ or DSP sound (See ”Advanced Sound” section
for details).
NOTE:
1) If there is interference, modify the location of the
antenna until the optional sound is heard. TV and
other electronic devices could be the cause of the
interference, so try to position the antenna away
from them.
2 ) A weak signal can affect the “Auto Search”
function. Adjust the antenna for better reception for
more efficient search.