GETTING STARTED
3
INSERTING BATTERIES INTO THE REMOTE
Insert two "AAA" batteries according to the + and -signs on the battery compartment. To use the remote
control, point it directly at your receiver.
SET UP AND MAINTENANCE OF THE RECEIVER
• Provide spaces for sufficient ventilation as indicated:
SURR. MODE TEST/SET UPPRESET EQ BY PASS
6 CH. P. SCANTUNING
• Do not connect the AC power cords until all connections are completed.
• Do not use your receiver immediately after transferring it from a cold place to a warm place; there is risk
of condensation.
• Do not expose your receiver to water and excessively high temperatures.
• After having disconnected your receiver, clean it with a soft cloth, or with a slightly damp leather
chamois. Never use strong solvents.
PROTECT YOUR COMPONENTS FROM OVERHEATING
• Do not block ventilation holes in any component. Arrange the components so that air can circulate freely.
• Do not stack components directly on top of each other.
• Allow adequate ventilation when placing your components in a stand.
• Place your amplifier near the top shelf of the stand so heated air rising from it will not affect other
components. If you have a satellite receiver, you shoud place it on the top shelf.
To Next Page
Need help?
General