10
R-Biopharm Rhone Ltd
4.1 Power Pack Notes
It should be noted that the KOBRA® CELL power
pack has been improved and as such is of a slightly
different design. The new power pack is still 9 V and
is supplied with an adapter for use in the UK, USA,
Europe and Australia. The plug can be converted
by depressing the button located at the top of
the adapter using a screwdriver. This releases the
adapter that is in position. Slide to remove. To attach
the required adapter place on the two pins and slide
to connect. The power pack can now only be used
at 100 µA and there is a light to show it has been
switched on (top right). There is also an error light
to indicate if there is a problem (bottom left).
4.2 Power Pack Technical
Specification
Power Supply Primary 110 - 240 V
Secondary 9 V
Exit Power
Current Source
100 µA
Maximum
Output Power
9 V
Loading Time
NICAD 9 V
Approximately 1 hour
15 minutes.
Accuracy 0.5 % (This is an improvement
on the previous model which
was 2 %.)
Working Time
with Battery
20 hours
Approval CE approval conforms to
European Directives 73/23/EEC
and 89/336/EEC.
4
KOBRA
®
CELL Installation
To Next Page
Loading...
Need help?
General