EasyManua.ls Logo

Raddy WF-60C - Auto DIM

Raddy WF-60C
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RCC
WF-60C WEATHER STATION
Press and hold theSETbutton to enter Setting Mode, then short
press theSETbutton twice, the auto dim icon will appear and the
Hour starts to flash.
Use the+/RCCand-buttons to set the correct hour for the
start time. Press and hold the+/RCCand-buttons will quickly
change the value by 8 steps.
Press theSETbutton to save your setting, the Minute starts to
flash. Use the+/RCCand-buttons to set the correct minute
for the start time.
Press theSETbutton to save your setting, the Hour starts to flash.
Use the+/RCCand-buttons to set the correct hour for the
end time.
Press theSETbutton to save your setting, the Minute starts to
flash. Use the+/RCCand-buttons to set the correct minute
for the end time.
Press theSETbutton again to save your setting and go to the next
item setting, or you can leave it alone. The unit will save your setting in
10 seconds and exit the Setting Mode if there’s no valid operation.
AUTO DIM
In Auto Dim Mode, the auto dim icon will show up and the backlight
brightness will be adjusted to 3% automatically. Backlight brightness will
be back to bright mode when out of auto dim period.
1. Set Time Period for Auto Dim Mode:
2.
3.
In Auto Dim Mode, short press theSNOOZE/LIGHTbutton, the
backlight will light up for 10 seconds, and then back to dim.
Turn On/Off Auto Dim: During the set auto dim time period, press and
hold theSNOOZE/LIGHTbutton to enable/disable the Auto Dim Mode.
This operation will be saved and will take effect on the next following
days until you turn it off/on next time during the set auto dim time period.
12

Related product manuals