PAGE 14
Low Speed Mute
If the current speed is slower than the speed in Low
Speed Mute which user set, Speed Camera, User Point,
Auto Lockout, X, K, POI Limit Speed Voice, Over Speed
Warning Voice will be Mute.
RLC Auto Mute
If the current speed is slower than the speed in RLC
Auto Mute which user set, Speed Camera, the alert for
Red Light Camera, Red & Speed Camera will be Mute.
Lockouts
The user can mute the frequency at the specific location
during alarming X, K band. Then, if the same frequency
(X, K band: +/-10MHz) is detected at the same location,
X and K alarm will be muted and the display will show
‘Lockout’ in green at the lower right corner until DS1
goes out of the 500m radius.
Lockout Range
Entry: approximately 450m
Exit: approximately 500m
If both Lockout and Auto Lockout are detected at the
same time, the display will show "Lockout."
To save a lockout
1. When X or K alerts, press [MUTE] to mute the voice
and beep alerts.
2. Press [MUTE] again to store the current location
and the frequency of the false alert. The display and
voice will say "Lockout Stored."
3. If the lockout is saved properly, the display will
To Next Page
Loading...
