PAGE 19
Option (1 sec, 2 sec, 3 sec). After DS1 gets Auto
Mute On, DS1 volume level sounds reduced by Auto
Mute Vol option percentage.
2. Auto Mute ends 10 seconds after the alarm ends. If
the same radar is detected within 10 seconds, the
unit keeps Auto Mute On.
3. Auto Mute is not applicable to Laser alert.
4. If the current volume level is 0, DS1 keeps the
current volume level.
Auto Dim Mode
DS1 has a light sensor to determine when the detector
should use the Bright settings (daylight) and when it
should use the Dim settings (nighttime). The brightness
set Bright or Dimmer depending on the brightness of
surroundings.
Auto Power Mode
1. If DS1 speed is 0 or DS1 cannot receive GPS location
data for the set time (15 min, 30 min), DS1 counts
Auto Power Off alarm about 10seconds and then
power off.
2. The Auto Power alarm stops if the user presses any
button during the Auto Power off alarm
3. The Brightness sets BRIGHT automatically.
(Auto Power Off Display)
Power Cord Alert LED
1. Power Cord Alert LED turns on when the power
turns on.
2. Power Cord Alert LED blinks when Laser or Radar (X,
To Next Page
Loading...
