PAGE 15
show "Lockout" in green in the lower right corner
until the DS1 is out of the 500m radius.
4. A maximum of 5,000 lockout points can be saved.
If the user wants to save an additional Lockout, the
oldest lockout will be deleted and the new lockout
will be saved.
To Delete a Lockout
1. When the DS1 gets a lockout signal, you will see
"LOCKOUT" in green in the bottom right corner
2. While "LOCKOUT is still displayed, press [MUTE].
The voice and display will say "Delete Lockout?"
3. Press [MUTE] again to delete. The voice and display
will confirm that the lockout was deleted.
DS1 does not save the Lockout due to the problem of
receving GPS location data, the voice says "GPS Error."
If GPS is unfixed, DS1 get Mute Off.
To Delete All Lockouts, select "Delete All Lockouts" in
the menu.
User Point Alarm
When User point is detected, the voice announces
(“User Point Ahead”) and shows User POI display.
User Point Alarm Range
- Entry : approximately 450m
- Exit : approximately 500m
To Save a User Point
Press [MUTE] for 2 seconds to save a User Point. When
a POI alert is detected, User point can not be saved. The
user can save a maximum of 5,000 points.
To Next Page
Loading...
