10
Preparation
CONNECTING TO AN
EXTERNAL SYSTEM
The Weatheradio’s ALERT OUT
terminals let you connect an external
module interface using twin-lead 20-
gauge cable (not supplied). Then you
can set the interface to sound an
audible or visible alert on a connected
appliance when a weather emergency
alert broadcast is received. Ô
1. Connect the Weatheradio
©
’s
positive (+) and negative (-)
ALERT OUT terminals to the
corresponding (+ and -) terminals
on the external system.
2. When you are finished, use a
pointed object (such as a
straightened paper clip) to press
on the orange tabs under the cable
wires, and gently pull on the wires
to remove them.
TESTING THE WEATHERADIO
In the United States, the NWS
broadcasts a test alert every week on
Wednesday between 11 AM and 1 PM.
To find out the specific test schedule in
your area, contact your local NOAA or
NWS office. These offices are usually
listed in the telephone book under “US
Ô NOTE Ô
Your local RadioShack
store carries a wide
selection of cable and
audible or visible alert
accessories.
To Next Page
Loading...
Need help?
General
