Operation
22
3. When a channel is detected,
W EATHER, CHANNEL#, AVLABLE, and
Ê appear.
4. If no channels are detected,
NO CH AVLABLE, BACK TO, and
CHANNEL # (last set channel)
appear.
Ê flashes.
5. The Weatheradio monitors the
signal strength at all the times. If
the signal is lost,
SIG LOSS appears,
and
Ê and the alert type LEDs
flash.
SETTING THE CLOCK
AND
ALARM
1. Press CLOCK to enter alarm
setting mode. If you have not set
the alarm before, --:-- appears.
2. Hold down
CLOCK for about two
seconds and release.
É and the
alarm hour digits flash.
3. Press
e
or
d
to select the desired
alarm hour.
PM appears to indicate
a PM hour.
4. Press
g
to confirm. The alarm
minute digits flash.
To Next Page
Loading...
