RADIOSHACK 6-IN-1 EASY SETUP VOICE REMOTE
12 Specifications
For more help, or if your issue is not listed, visit
www.radioshack.com or call 866-269-8705.
SPECIFICATIONS
Remote Power ..............................(4) AAA Batteries
Remote Dimensions
(H x W x D)..............................9.01 x 2.68 x 1.19 in.
.................................... (228.79 x 68.15 x 30.13 mm)
Remote Weight (no batteries)....... 5.6 oz (158.75 g)
NOTE: Specifications are typical. Individual units
might vary. Specifications are subject to change and
improvement without notice.
CARE
• Keep the remote dry. If the remote gets wet,
wipe it dry immediately.
• Handle the remote gently and carefully. Don't
drop it.
• Use and store the remote only in normal
temperature environments.
• Keep the remote away from dust and dirt.
• Wipe the remote with a damp cloth to keep it
looking new.
• Modifying or tampering with internal parts
can cause damage and invalidate the warranty.
If your remote is not performing as it should,
please contact us at:
www.radioshack.com
or visit your local RadioShack store for help.
PROBLEM: The unit does not control home
entertainment devices or
commands are not working
properly.
SOLUTION: Try all listed codes for the device
brands being set up. Make sure
they can be operated with an
infrared remote control.
PROBLEM: Tried Searching For Your Code
method and still could not find a
working code.
SOLUTION: Perform Restoring Factory Default
Settings on page 11. Then repeat
Searching For Your Code on page
7.
PROBLEM: Cannot program a macro onto M1
– M2 or POWER keys.
SOLUTION: Make sure the total number of key
presses being programmed for
each macro is less than 15.
PROBLEM: Power macro does not execute.
SOLUTION: Press and hold POWER for more
than 2 seconds.
PROBLEM: Favorite channel function does
not work properly.
SOLUTION: Some devices (e.g.,Cable Boxes or
Satellite Receivers) use two-digit
channel numbers. During
programming, press ENTER or OK
once after entering a channel
number (e.g., 0 2 ENTER for
channel 2). See Programming
Favorite Channel Scan on page 7.
PROBLEM: Changing channels does not work
properly.
SOLUTION: If the original remote control
required pressing ENTER to
change channels, then press
ENTER on the remote control after
entering channel numbers.
PROBLEM: No remote control of volume.
SOLUTION: See Changing Volume Lock on
page 7 to lock/unlock volume.
PROBLEM: LED flashes when a key is
pressed, but home entertainment
device does not respond.
SOLUTION: Make sure the remote control is
aimed at your home
entertainment device and is not
farther than 15 feet away.
PROBLEM: CHS and CHTdo not work for
your RCA TV.
SOLUTION: Due to RCA design (1983-1987),
only the original remote control
will operate these functions.
RS 6in1 Easy Setup Owners Manual.fm Page 12 Wednesday, December 15, 2004 10:31 AM
To Next Page
Loading...
Need help?
General
