Radio Shack 22-168A - Preparation for Use; Installing and Replacing the Battery

PREPARATION
INSTALLING/REPLACING THE
BATTERY
Your meter requires a 9V battery (not supplied)
for power. For reliable operation, we recommend
an alkaline battery, such as Radio Shack Cat.
No. 23-553.
Warning: TO AVOID ELECTRIC SHOCK, DIS-
CONNECT BOTH LEADS FROM ANY EQUIP-
MENT BEFORE YOU REMOVE OR INSTALL
THE BATTERY.
Follow these steps to install the battery:
1. Tum off power and disconnect the two test
probes.
2. Loosen the battery compartment cover screw
and slide off the cover. Remove the old battery,
if necessary.
Qe
)
3. Place the battery into the supplied insulation
capsule and snap it onto the contacts.
S=
(4
———
Warning: Do not discard .the provided bat-
tery insulation capsule. If you do not use
this insulation capsule properly, damage or
injury might result.
4. Replace the battery compartment cover and
secure it with the screw.