Radio Shack 22-168A - Replacing the Fuse; Fuse Replacement Procedure

REPLACING THE FUSE
WARNING: TO AVOID ELECTRIC SHOCK,
DISCONNECT THE TEST PROBES BEFORE
REMOVING THE BATTERY OR THE FUSE.
REPLACE ONLY WITH THE SAME TYPE OF
BATTERY OR FUSE. SERVICE SHOULD BE
PERFORMED ONLY BY QUALIFIED PERSON-
NEL.
CAUTION: For continued protection against fire
or other hazard, replace only with a fuse of the
specified voltage and current ratings.
F1—Radio Shack Cat. No. 270-1052
F 2—Radio Shack Cat. No. 270-1041
Follow these steps to replace the fuse.
1. Tum off the meter and disconnect the test
probes.
2. Remove the cover by unscrewing the four
screws and pulling off the meter’s cover.
3. Remove the blown fuse.
rov| bs (=
c= oo oo
Fl F2
4. Install the new fuse in the fuse compartment.
5. Replace the cover and secure it with the
screws.
WARNING: DO NOT OPERATE YOUR METER
UNTIL THE BACK COVER IS IN PLACE AND
FULLY CLOSED.
43