Radio Shack 22-168A - Page 40

40
. Insert the supplied diskette in your compu-
ter’s 3'-inch drive.
. Create a directory on your hard disk for the
software. For example, to make a directory
called METER for the software, type:
cd \(ENTER)
md METER (ENTER)
. Make the directory you created the current
directory. For example, if the. directory is
METER, type:
cd\ METER (ENTER)
}. Copy the files from the GRAPHIC subdirectory
on the floppy drive to your hard disk. For
example, type:
copy a:\GRAPHIC c:
. To run the program, type RS (ENTER).
Follow the on-screen help for specific opera-
ting instructions.
Notes:
* If you do not have a hard disk, you can still
run the program from the supplied floppy dis-
kette. Change to the GRAPHIC subdirectory
on the diskette, and type RS CENTER).
© To stop the program or to escape from a de-
vice I/O error, press (CTRL+BREAK).
Using the Windows Software
Follow these steps to install and run the Windows.
software.
Note: The following steps assume a basic knowl-
edge of Microsoft Windows. Refer to your com-
puter’s Windows User's Guide for information
about using Windows. This software requires
Microsoft Windows, Version 3.1 or later and a
VGA or EGA display.
1. Start your computer and run Windows.
2. Insert the supplied diskette in your computer's
3%-inch drive.