Radio Shack 2200813 - Additional Product Information; Fuse Replacement Guide

18
Additional Info
Additional Information
Replacing the Fuse
If the meter does not operate or “FUSE Bad”
appears on the display, you might need to
replacethefuse.Usethesuppliedspare
fuseora5×20mm,500mA,250VCooper
BussmannS501seriesfuseorequivalentsand
filled ceramic fuse.
1. Turn off the meter and disconnect the test
leads.
2. UseaPhillipsscrewdrivertoopenthe
back cover of the meter.
3. Gentlypulltheredribbonwrapped
around the fuse to pop it out.
4. If the fuse is blown, discard it and save the red ribbon. Place the supplied spare fuse
into the ribbon, and insert the fuse into the fuse holder.
5. Replace the back cover.
nNote:Donotuseafusebrandorratingotherthantheonespeciedhere.Doingso
might damage your meter.
Fuse
Installed
Spare Fuse