Radio Shack DX-394 - Receiver Operation Basics; Initial Power-On Procedure; Using the Mode Control

RECEIVER OPERATION
S
4. Tum VOLUME fully counterclockwise
and RF GAIN fully clockwise before
you turn on the racsivar.
2. Solect the operation mode —
STANDBY, AM, LSB, USB, CW1, or CW2
(ses "Using the Mode Contror).
5. Pr
Note: If the clock display is flashing,
set
the
time
(see
"Setting
the
Clocks?)
4. Press BAND until the desired band
(EM, ми, or BW) appears on the dis-
play (see "Selecting the Banc").
5. Tune to the desired station (seo "Tu-
ning to a Station’)
5, Adjust VOLUME as desired.
7. Pross POWER again to turn off the
receiver,
USING THE MODE CONTROL
Tho MODE switch seting cetermines tho
‘ype of signal that your recaivar raceives.
For standard broadcast and international
‘use the AM postion.
Гог тое code, uso Ст cr Сма. For
388 signals, use the LSB or USB position.
то help you decido whether to use USB
(upper
sideband)
or
LSB
(lower
sidebanc),
oo tho following chart.
$s POWER to turn on the receiver.
‘This chart shows the normal sideband
mode used for the Ham bands.
4
(When receiving SSB on other bands, try.
both USB and LSB until you are abla o
identity the signal.)
| m [m
Notes:
*
If
you
tune
through
SSB
signals
while
in
the
AM
modo,
you
hear
only
flutto-
‘ing
sound.
Switch
to
the
LSB
or
Us
mode.
*
I
you
tune
through
AM
signale
while
ucing
tho
L68
or
USB
modo,
you
heer
а
very
annoying
background
tone,
which
varies
wih
the
seting
of
the
tuning
controle.
If this
happens,
switch
10
the
AM
mode.
+
Setting
MODE
lo
the
STAND
BY
posi-
"ion
prevents
you
from
changing
the
‘main
tuning
knob
апа
al
buttons,
except
POWER.
This
position
also
turns
of
the
sound.