Radio Shack DX-394 - Tuning to Broadcast Stations; Manual Tuning Methods; Direct Access Tuning; Search Tuning Function

TUNING TO A STATION
You can tune to a desired broadcast sta-
don using the manual, direct access,
search, or memory tuning methods. Use
‘he lower keypad or main tuning knob to
‘une broadcasts,
Manual Tuning
To
manually
tune
to
a
frequency,
repeat-
edly
press
A
or
Y
or
rotate
the
main
tu-
ning
knob
unti
the
display
shows
the
desired
froquoncy.
Direct Access Tuning
1. Press FREQ. The frequency disolay
Meshes for about 10 seconds.
2. While the frequency display fiashos,
press the number koys, including tho.
‘decimal key, to select the desired sta-
licn's frequency.
d. Prose ENT.
Note
+ Myou make a mistake, press CLEAR to
erase no last digit.
* M you do not press a key tor more tan
10 seconds, the display stops flashing.
Start again rom Step 1
+ M you wy о eter an invan trequency,
Error appoa's on the display. Press
CLEAR or wait 5 soconds unti Error
disappears from the display-
16
*
Your
receiver
automatically
rounds
down
the
entered
frequency
to
the
nearest
valid
frequency.
For
example,
if you
ty
to
enter
a frequency
of
478
in
IW,
your
receiver
accepts
it
as
470
илеп
the
frequency
step
is
set
io
10
kHz
—
see
“Setting
the
Frequency
Step).
Search Tuning
To automatically tune up or down to tha
next
frequency
in
the
selected
LW,
MW,
SW band, 13 intornatioral broadcast band
(meter), or lim frequency band, press
and hole down А or Y for about 2 ee
'conds. The receiver searches up or down.
in tho selected band and tunes to the first
frequency # finds with a strong signal.
Notes:
*
To
tune
to
stations
with
weaker
sig-
nals,
use
one
of
the
marual
tuning
methods.
* I the RF GAIN is sel fully clockwis
"he receiver might not search up or
down when you press А or Y. Turn
the RF GAIN control counterclockwise.
Press A or Y for about 2 seconds to
restart tho search.