Radio Shack DX-394 User Manual

АТТ ANT ANT
odB 2008 LOZ Hi-Z
To Receivers
GND Terminal
© ©
A dipole antenna is made up ol lwo peces
ol wire, each һай of the total length. Con-
noct the artenna's PL-259 plug to he ANT
10:2 jack on the back of the receiver.
Caution: Do not run tha cable aver sharp.
edges or moving objects.
Warning: Usa axtreme caution when you
install
or
remove
an
outdoor
antenna.
If
The amanna starts to fall, let it gol It souks
contact overhead power lines. | the
antenna touches a power line, contact
with the antenna, mast, cable, or guy
wiron can cause electrocution and death.
Cali ne power company to remove the
antenna.
DO
NOT
attempt
to
do
so
your-
sel.
GROUNDING
To insure the best reception, you must
always
connect
a
heavy
gauge
ground
wire (not supplied) to the GND screw on
tho back of the receiver. Connect the
other end either to a metal cold wate” pipe
{not hot watar and not natural gas pipe) ог
fo a motal ground rod (not supplied)
driven into the ground. Or, you can bury а
‘copper plato or copper net in tne ground
and connect to i
Ground Rod
Underground
For more information about antennas and
grounding,
obtain
a
copy
of
"The
ARAL
Amateur Radio Handbook,” available al
‘your
local
Radio
Shack
Tandy
store.
CONNECTING POWER
Connecting AC Power
Plug the receiver's AC power cord into а
standard AC oue!
Caution:
1o
prevort
olectrc
shock,
the
plugs
blaces
are
polarized
and
tit
only
опе
way.
Ifthe
plug
does
not
ft
easily,
turn
over
and
try
again.
Do
not
foroa
tha
plug
into
the
AC
outlet.

Radio Shack DX-394 Specifications

General

Brand	Radio Shack
Model	DX-394
Category	Receiver
Language	English