Radio Shack DX-394 - Band Selection and Tuning Limits; Selecting Radio Bands; Selecting International Frequency Bands; Setting a Limit Tuning Range

SELECTING THE BAND
To select the long wave (LW). medium
wave (MW), or short wave (SW) band.
press
BAND
unti
the
desired
band
appears on the ерау.
Cc rrr
eo ee
Selecting the International Radio
Frequency Band
1, Press METER to display the current
meter band,
2. Press METER agein И you want to
change the meter band. Tne meter
band flashes tor 10 seconds.
з. Whio the moter bund flashes, press the
desired meter band key. For examp, to
soloct the 90 mutar bad. press tom.
SETTING A LIMIT TUNING
RANGE
You can set a frequency range во you can
tune to frequencies between lowor and
upper limita,
1. Proce LIMIT. LIMIT appears on tho
display
2. Press POM. A flashes for about 10
seconde
Его”
the
lower
limit
of
tho
frequency
range
including
the
decimal
point.
+ To sel 150 kHz, enter 150.
® To set 1 MHz, enter 1000 or 1.
+
To
sot
10
MHz,
entor
10000
or
10.
Note:
+ you try to enter invalid frequency
(100, for example), Error appears
on the display. Press CLEAR or wait
5 seconds urtil Error disappears
from the display.
+ You cannot use the main tuning knob
to кө! a imit tuning range:
4. Press LIMIT, Y flashes for about 10
5
Enter
the
upper
Imit
of
the
frequency
range
including
the
decimal
point.
6. Pross ENT.
7. Press A or ¥ to search through the
frequencies in the selectod band.
Notes:
*
M
you
make
a
mistake
in
Stop
3
or
5,
press
CLEAR
to
erase
the
last
digit.
^
It
you
wait
more
than
10
seconds
to
rese
a key.
You
must
begn
again
at
Step
2
*
To
тшт
to
the
previous
mode,
press
UNIT
unti
LIMIT
disappoars
from
tho
iplay.
The
limit
tuning
range
is
stored
in
memory
until
you
seta
new
range.
15