Radio Shack DX-394 - Clock and Timer Functions; Setting the Receiver Clocks; Programming a Timer

CLOCK RADIO OPERATION
SETTING THE CLOCKS
Your receiver has two clocks. We recem-
mend you set the primary clock to the
loca time and the secondary clock to the
UTC (Coordinated Universal Time — alse
called
Greenwich
Mean
Time)
Note: The receiver's time display uses the
24-hour format.
1. Press and hold down TIME SET for 2
seconds. C is selected ard Ihe ime
diis flash on the display.
2. While the clock display flashes, use
the number keys to antar the correct
"imo. For example, exter $30 for 6:30.
Note: if you make a mistake, press.
CLEAR to erase the last git.
3. Prose TME SET lo select E, . The
how digit flashes,
4. While the hour digit flashes, use the
rubar keys to enter the hour fcr tho.
second clock.
20
Note: You only need to enter the hour.
For example, enter 4 for 4:30. The
minutes
change
automaticaly
accor-
ding їс the primary clock satling.
5. Press ENT to star: toth clock 1 and
lock 2. The colon flashes,
Press TIME SET to altorrate between the
lie on clock 1 and clock 2.
USING THE TIMERS
Your receiver has five programmablo ti-
mers. You can store a turing frequency
and onof times into each timor. Whon
you turn on a timer, the receiver automati-
‘ally turns on and tunos to tho pro-
grammed
frequency
when
tho
timor
feachet the programmed time. When it
reaches the off time, the racaiver turns ой.
Note: The timers are set to Clock 1.
Programming a Timer
1. Set the frequency that you want the
receiver to tune to when И turns on.
example, sot 12 345 MHz.