6.  If necessary, use the number keys to enter a 
new Offset frequency and press ENT. The S 
in Step blinks.
If you try to program an offset frequency 
in the UHF-Hi bands (806-960 MHz), the 
scanner ignores the entry.
7.  While the S in Step blinks, repeatedly press 
 or  to select the step number: 5.0, 
6.25, 10.0, 12.5, 15.0, 18.75, 20.0, 25.0, 30.0, 
31.25, 35.0, 37.5, 40.0, 43.75, or 50.0 kHz, 
then press ENT.
8.  Press PGM.
UHF-Hi (806-960 MHz) 
To program 800 MHz Motorola trunking:
1.  Press PGM then TRUNK to enter the ID 
program mode.
2.  Press FUNC, then press  or . The bank 
number increases or decreases by one. If 
you hold down  or , the bank number 
increases or decreases continuously.
3.  If necessary, repeatedly press MODE to 
select “Motorola.”
4.  Press FUNC then 3. NORMAL appears.
5.  Press  or  to select NORMAL or 
SPLINTER and press ENT. If you are 
uncertain about the base frequency, use 
NORMAL. 
  The base frequency in NORMAL is 851.0125 
MHz. The base frequency in SPLINTER is 
851.0000 MHz. . If you cannot receive with 
the NORMAL setting, change to SPLINTER. 
EDACS Trunking Setup
EDACS (GE/Ericsson) systems transmit Talk 
Group ID data on a dedicated control channel. 
Scanning requires clear reception of the 
control channel at all times, so EDACS systems 
generally have a smaller usable area. You 
can manually select the data channel, but an 
external antenna can greatly improve EDACS 
scanning. If you are programming frequencies 
for an EDACS sysstem, you must store them 
in the Logical Channel Number order (usually 
listed as LCN#).
LTR Trunking Setup
LTR systems, assign each frequency a Home 
Repeater (HR) number, and are frequently 
programmed with unique ID codes for each 
radio. LTR Talk Group IDs are organized in a 
specic order, and to scan, you must program 
the frequencies in HR order. LTR systems are 
used primarily by businesses, such as taxicabs, 
delivery trucks, and repair services.
LTR systems use a Home Repeater as part of 
their Talk Group ID.
To save a correct Home Repeater: 
1.  Save the LTR channels in any order. 
2.  Set the bank to Open mode. 
3.  Manually select LT channels and watch the 
LTR data on the display. 
  Your scanner displays the LTR Talk Group 
ID and a number preceded by “R.” The “R” 
number is the Home Repeater number for 
the transmission. 
4.  The assigned Home Repeater channel must 
equal the Home Repeater number. For 
example, R12 must be programmed into 
Channel 12.