— appears when Signal Stalker is active.
SCAN
— appears when you scan channels.
LIST
— appears with numbers (1–5) during trunking.
Numbers with a bar under them show which ID scan list
banks are turned on for scanning.
SRCH — appears during chain, direct, and ID searches.
SVC — appears during Service Search mode.
PRI
— appears when the priority feature is turned on.
HOLD
— appears during chain, direct, service, and ID
searches, and ID monitor holds; flashes while the scanner
is temporarily monitoring a programmed ID.
DLY — appears when you select a Dropout Delay option.
L/O
— appears when you manually select a channel
and talk group you locked out.
— appears when you lock the keypad.
— alerts you when the battery power gets low.
— appears when you select Skywarn channel.
PGM
— appears while you store a frequency into a channel,
while you enter a frequency range during a chain
search, or when you program trunking frequencies, fleet
maps, or ID memories while trunking.
or — appears during a chain, direct, or service
search, and normal and weather scan
indicating the search direction.
ALERT
— appears when the weather alert is turned on,
or flashes when the scanner detects an alert coded signal.
M,
E or L — indicate either a Motorola (M) trunking system,
EDACS (
E) system or LTR (L).trunking channel.
CH
— appears with a number to its left to indicate to
which channel the scanner is tuned to.
UNDERSTANDING BANKS
To Next Page
Loading...
