•
PGM to store the displayed frequency into the memory.
To release the hold and continue searching, press HOLD/RESUME
Note: Because there are many different frequencies allocated to fire and police departments, it can take several
minutes to search all the service frequencies.
Weather Search
You can search also for weather transmissions. To start weather search:
1. Press
WX/ . WX appears. You can change the search direction by using or .
2. If you want to stop the search, press
HOLD/RESUME. HOLD appears.
Search Skip Memory
You can skip up to 200 specified frequencies during a chain, direct and service search and Signal Stalker .This
lets you avoid unwanted frequencies or those already stored in a channel.
Note: You cannot skip frequencies during WX service search.
To skip a frequency, press
L/O when the scanner stops on the frequency during a chain, direct and service
search and Signal Stalker. The scanner stores the frequency in memory and automatically resumes the search.
To clear a single frequency from skip memory so the scanner stops on it during a chain, direct and service
search and Signal Stalker:
1. Press HOLD/RESUME to stop the search.
2. Press or to select the frequency. L/O appears.
3. Press
L/O. L/O disappears.
To clear all the skip frequencies at once while searching, press
HOLD/RESUME, then hold down L/O until the
scanner beeps twice.
Notes:
• If you selected all frequencies to be skipped within the search range, the scanner beeps 3 times and
does not search.
• If you select more than 200 frequencies to skip, each new frequency replaces a frequency previously
stored, beginning with the first stored frequency.
• Press
or to select a skipped frequency while HOLD appears. L/O appears when you select a
skipped frequency.
SCANNING THE STORED CHANNELS
To begin scanning channels, press
SCAN/MANUAL. The scanner scans through all non-locked channels in the
To Next Page
Loading...
