2. If you want to add or delete the bank to be searched, press 0 – 9 corresponding the bank.
Note: At least one bank needs to be entered. If you disabled all the banks, the error tone beeps.
3. Press
to search down or to search up.
4. When the scanner stops on a transmission, quickly press either:
HOLD/RESUME to stop searching to listen to the transmission. HOLD appears.
PGM to store the displayed frequency into memory.
5. To release the hold and continue searching, press
HOLD/RESUME.
Note: To step through the frequencies while HOLD appears, press or .
Direct Search
You can search up or down from the currently displayed
frequency using direct search.
SRCH appears during searching until the scanner stops.
1. Press and hold SRCH.
OR
Enter the frequency you want to start from using the number keys,
press • to enter a decimal point, then press or . .SRCH appears.
Note: If you enter an invalid frequency, the scanner displays
Error. Press ・/CLR /DELAY.
2. When the scanner stops on a transmission, quickly press either:
HOLD/RESUME
to stop searching and listen to the transmission. HOLD appears.
PGM to store the displayed frequency into memory.
3. To release the hold and continue searching, press HOLD/RESUME .
Note: To step through the frequencies while
HOLD appears, press or .
Service Bank Search
You can search for ham, marine, aircraft, or police (fire/emergency) transmissions without knowing the
specific frequencies used in your area. The scanner is preprogrammed with all the frequencies allocated to
these services. To use this feature, press
SVC. The current service symbol appears and the scanner starts to
searching. To select a different service bank, press 1/HAM, 2/MRN, 3/AIR or 4/POL.
Newly selected service symbol appears. Press
to search down or to search up.
When the scanner stops on a transmission, quickly press either:
•
HOLD/RESUME to stop searching and listen to the transmission. HOLD appears.
To Next Page
Loading...
