1 S3 1 S3 1 S4
2 S11 2 S10 2 S4
3 S4 3 S4 3 S11
4 S4 4 S4 4 S11
5 S0 5 S4 5 S0
6 S0 6 S12 6 S12
7 S0 7 (S12) 7 (S12)
E1P16
Size
Block Code
0 S3
1 S10
2 S10
3 S11
4 S0
5 S0
6 S12
7 (S12)
Selecting a Preset Fleet Map
1. Set the scanner for conventional scanning and
press TRUNK to select the trunking programming mode and the bank you want to change.
2 Repeatedly press
or to select TYPE 1 SYSTEM (E1), then press E/PGM.
3. Repeatedly press or to select FLEEt, then press E/PGM.
4. Repeatedly press or to select the name of the desired map (example E1P7).
The preprogrammed fleet map appears.
5. Press
E/PGM . The scanner return to fleet map list item.
Note: When the scanner searches for transmissions, you see Type I fleet and subfleet IDs
such as
100-12, 100-9, 000-12, or 400-8.
How do you know if the preset map you selected is correct?
Listen to find out if you are following complete conversations. If not, try another preset map.
Programming a Fleet Map
1. Select the trunking programming mode and the bank you want to change.
2. Repeatedly press
or to select Type 1 System (E1), then press E/PGM.
3. Repeatedly press
or to select FLEEt, then press E/PGM.
A preprogrammed fleet map appears.
4. Repeatedly press
or until USr appears. Then press E/PGM.
To Next Page
Loading...
