63
Dedicated Searches
The following information is displayed for each trunking mode:
Trunked Mode Analysis Display
Motorola 3600
baud control
channel
qq% SID:ssss Stt
qq = decoding quality of the control channel data, SID = System
ID, and
S = Site Number
P25 9600 BPS
control channel
qq% Nnnn W:wwwww
Sys:sss Rrr Stt
qq = decoding quality of the control channel data, N = NAC, W =
WACN, SYS = System ID, R = RFSS, and S = Site Number
EDACS control
channel
qq% S:ss h/H s/S a/A
qq = decoding quality of the control channel data, S = Site ID,
h/H = not home site/is home site, s/S = not SCAT site/is SCAT
site, a/A = not Aux CC/is Aux CC
LTR home
repeater
HR:hh A–HH–GGG
HR = the home repeater number of the tuned frequency, A-
HH-GGG = the Area, Home Repeater and Group ID of the LTR
talkgroup
Motorola
analog voice
channel
VC: lsTGID–nnnnn
lsTGID = the decoded talkgroup ID data from the lowspeed data
stream
Note that the analog lowspeed data protocol does not provide
error correction, and some false “VC: lsTGID” readings should be
expected.
Tune LED
Tune LED can provide visual indication of signal strength using the
tri-color LED.
To activate the Tune LED:
1. Press PROG for Program Mode.
2. Press GLOB softkey.
3. Press q to select Tune LED:.
4. Press t or u to select Tune LED on or off.
5. Press the SAVE softkey to save your changes to the radio’s
configuration memory.
To Next Page
Loading...
