Scanner Setup
Installing Your Scanner
You can mount your scanner in your vehicle or use it as a base
station.
Setting up a Mobile Base
You can place your scanner on a desk, shelf, or table to use it as a
base station. Because the speaker is on the bottom of the scanner,
use the mounting bracket to elevate your scanner off the surface for
better sound.
To use the scanner on a flat surface:
1. Attach the three protective
rubber feet to the
mounting bracket.
2. Slide the scanner into
the bracket, aligning
the scanner’s side holes
with the holes in the
bracket,
and then screw the
mounting
knobs into the scanner.
Bracket Mounting
You can mount your scanner under or on top of the dashboard a
desk, shelf, table or other flat surface, using the mount bracket.
1. Use the supplied mounting bracket as a template to make
positions for the two mounting screws.
2. At the marked positions, drill holes slightly smaller than the
screws. When drilling holes, avoid obstructions behind the
mounting surface.
To Next Page
Loading...
