Temporary Lockout
Temporary lockout locks out an object until the scanner is turned off.
When the scanner is powered on again, all objects that have been
temporarily locked out are restored.
To temporarily lockout an object:
1. When the scanner stops on an object, press L/OUT.
or
1. In Manual Mode or Program Mode, press p, q, t or u to
select an object.
2. Press L/OUT.
The lowercase “l” in the display flashes to indicate the object is
temporary lockout.
To unlock a temporary lockout object:
1. In Manual Mode or Program Mode, press p, q, t or u to
select an object.
2. Press L/OUT.
HINT: You can also toggle lockout anytime you are viewing an object
menu in Program Mode by pressing L/OUT.
Permanent Lockout
Permanent lockout locks out an object until you explicitly unlock it.
No traffic will be received on the locked out object while permanent
lockout is active.
1. When the scanner stops on an object, press FUNC, then L/OUT.
or
1. In Manual Mode or Program Mode, press p, q, t or u to
select an object.
2. Press FUNC, then L/OUT.
To Next Page
Loading...
