According to the Electronic Communications Privacy Act (ECPA), you are
subject to fines and possible imprisonment for intentionally listening to,
using, or divulging the contents of such a transmission unless you have
the consent of a party to the conversation (unless such activity is
otherwise illegal). We encourage responsible, legal scanner use.
(br/km-04/14/1997)
PRO-67 Scanner
(200-0512) Preparation Faxback Doc. # 38890
POWER SOURCES
You can power your scanner from any of three sources:
Internal batteries (not supplied)
Standard AC power (using an optional AC adapter)
Vehicle battery power (using an optional DC adapter)
Using Internal Batteries
You can power your scanner using four AA batteries. For the longest
operation and best performance, we recommend you use alkaline batteries
(such as Radio Shack Cat. No. 23-552).
You can also use rechargeable nickel-cadmium batteries (Cat. No. 23-125).
Before you use nickel-cadmium batteries, you must charge them.
Follow these steps to install batteries.
1. Turn VOLUME/OFF counterclockwise until it clicks, to make sure power
is turned off.
2. Push up the tab on the back of the scanner and lift open the battery
compartment cover.
3. If you are installing alkaline or general purpose batteries, set
ALKALINE <- JACK -> NI-CD to ALKALINE inside the compartment using a
pointed object such as a pen. Or, if you are installing
nickel-cadmium batteries, set ALKALINE <- JACK -> NI-CD to Ni-CD.
Warning:
Never set the battery switch to NI-CD when you have non-rechargeable
batteries installed inside the battery compartment. Non-rechargeable
batteries can get hot or explode if you try to recharge them.
To Next Page
Loading...
