RadioLink Electronic Limited
www.radiolink.com
Note The telemetry of model voltage can only be realized with the receiver R7FG/R8F.
1. Put the transmitter and the receiver close to each other (about 50 centimeters) and power
both on.
2. Switch on the transmitter and the led on R6FG will start flashing slowly.
3. There is a black binding button(ID SET) on the side of receiver. Press the button for more than
1 second and release, the led will flash quickly, meaning binding process is ongoing.
4. When the led stops flashing and is always on, binding is complete and there will be a signal
tower shown on top of the LCD screen of the transmitter. If not succeed, the led will keep flashing
slowly to notify, repeat the above steps.
Note NO gyro by default as factory setting. Since integrated gyro in R6FG will self-check, it is
very important to remain R6FG still when powering it on. There are two LED indicators on R6FG.
GREEN indicates the normal working mode while RED indicates the gyro working mode. When
RED is off means NO gyro. If binding is not successful, the green led will keep flashing to notify.
Note of Receiver Usage
1. Keep antennas as straight as possible, or the effective control range will reduce.
2. Big models may contain metal parts that influence signal emission. In this case, antennas
should be positioned at both sides of the model to ensure the best signal status in all
circumstances.
3. Antennas should be kept away from metal conductor and carbon fiber at least half inch away
and no over bending.
4. Keep antennas away from motor, ESC or other possible interference sources.
5. Sponge or foam material is advised to use to prevent vibration when installing receiver.
6. Receiver contains some electronic components of high-precision. Be careful to avoid strong
vibration and high temperature.
7. Special vibration-proof material for R/C like foam or rubber cloth is used to pack to protect
receiver. Keeping the receiver in a well sealed plastic bag can avoid humidity and dust, which
would possibly make the receiver out of control.
When all the above steps are complete, please turn off the transmitter and re-power on to test if
the receiver is correctly connected with it.
R6FG Working Mode
R6FG has two working modes：normal working mode and gyro working mode.
(1) Normal Working Mode
Green LED, gyro will NOT be working.
(2) Gyro Function Working Mode
Both GREEN and RED LED on.
To Next Page
Loading...
