RADWAG AS PLUS Series User Manual

- 57 -
3
Flexible connector
9
Sinker
4
Top weighing pan for solids
density determination
10
Beaker basis
5
Beaker
11
Additional stand for a set of pans or a sinker
6
Hanger
12
Additional set of weighing pans for density
determina
tion of solids with density lower that density
of water
Kit intended for AS balances.
1
Beaker base
8
Hanger
2
Stand
9
Top weighing pan for solids density determination
3
Sinker
10
Flexible connector for weighing pans
4
Beaker
11
Bottom weighing pan for solids density determination
5
Thermometer holder
12
Additional sinker
6
Thermometer
13
Additional stand for a set of pans or a sinker
7
Flexible connector for
sinker
14
Additional set of weighing pans for density determination of
solids with density lower that density of water
Installation procedure:
AS balances
PS balances
CAUTION!
• Components of density determination kit shall be stored in a respective box.
• Weighing pans and sinker shall not be put directly on a table, this might cause their damage.
• Weighing pans and sinker, if not operated, shall be put on an additional stand.
• If the kit has been installed and -nuLL- message is displayed than the balance shall be loaded with
weights set (12). Thus prepared balance can be used for density determination.

RADWAG AS PLUS Series Specifications

General

Display	LCD with backlight
Power Supply	100-240 V AC 50/60 Hz
Calibration	Internal / External
Interface	RS232, USB-A, USB-B
Operating Temperature	+10° - +40°C
Pan Size	ø 85 mm
Repeatability	0.1 mg
Linearity	±0.2 mg
Stabilization time	2-3 seconds