RADWAG AS PLUS Series User Manual

- 75 -
“Ready to Install” window:
In order to run installation process, press „Install” key
and clicking respective keys, follow the install wizard.
2.
Having completed driver installation, connect balance
to a computer, use 1,8-
meter long USB A/B cable
maximally (in the case of already connected balance,
it is necessary to disconnect it and using USB cable
connect the balance again).
3.
The system detects the new USB device and automatically starts searching a respective driver

RADWAG AS PLUS Series Specifications

General

Display	LCD with backlight
Power Supply	100-240 V AC 50/60 Hz
Calibration	Internal / External
Interface	RS232, USB-A, USB-B
Operating Temperature	+10° - +40°C
Pan Size	ø 85 mm
Repeatability	0.1 mg
Linearity	±0.2 mg
Stabilization time	2-3 seconds