8. FACTORY SETUP
To access and modify both factory settings and parameters that are made
available for a user, run Factory Setup mode. Running Factory Setup mode
enables the technician to define the balance.
8.1. Access
Switch the weighing device off, to do it press key.
Press and hold S1 switch located on the electronics board, while holding
the S1 switch, press key to run the weighing device.
Access to factory setup switch
Wait as long as the scale restart is in progress.
Press and key combination, message <P0.FAct> is displayed.
Press key to go to factory parameters' submenu no. 1.
After completed factory parameters setup, restart the
weighing device.
To Next Page
Loading...
