In order to finish entering linearity correction points press key,
<0.4.1.dSG> submenu is displayed.
8.5.2. Corrections
It is possible to enter extra corrections for declared linearity correction points.
Procedure:
Enter factory setup submenu: <P.0.FAct / 0.4.Line / 0.4.3.Cor>, value
of linearity correction point no.1 is displayed.
Press key, window for entering correction value for linearity
correction point no. 1 is displayed.
If there is a need to enter negative value, go to the first digit and press
key.
Press key to confirm, modified correction point value is displayed.
Go to the next linearity correction point, to do it press key.
Correcting the linearity correction point no. 2 is analogous.
In order to finish correcting linearity correction points press key,
<0.4.3.Cor> submenu is displayed.
8.5.3. Deleting Linearity
Enter factory setup submenu: <P.0.FAct / 0.4.Line / 0.4.2.dEL>, text
<Cont?> is displayed.
Press key to confirm.
Exit to the home screen, to do it press key repeatedly.
8.6. Gravitational Coefficient
The function of gravity correction compensates changes of gravity force being
a result of different latitude. It allows to carry out correct scale
calibration/adjustment away from the place of subsequent use. The value
of gravity correction must be entered with reference to tables prepared by
„RADWAG Wagi Elektroniczne” or calculated using the below formula:
To Next Page
Loading...
