RADWAG PUE H315

9
4.5. Technical specifications
Housing
Stainless steel
Ingres Protection
IP 66 / IP 67 / IP 69
Operating temperature
-10°C to +40°C
Display
LCD
Power supply
100 ÷ 240VAC 50÷60Hz
Optional supply
External 12-24VDC
OIML Class
II and III
Max. of verification interval (n)
6000
Maximum signal increase
39mV
Min. voltage per verification interval
0,4uV
Min. impedance of load cell
50
Max. impedance of load cell
1200
Load cell supply
5V
Load cell wiring
4 or 6 wires with shield
Max. number of platforms
1
Multirange
Yes
RS232 (1)
M12 8P connector
USB
M12 4P connector
Optional Equipment:
RS232 (2)
M12 8P connector
RS485
M16 cable gland
Ethernet
M12 4P connector
4-20mA current loop
M16 cable gland
4IN/4OUT
M16 cable gland
Battery supply
Rechargeable battery 6 x NiMH AA/R6
5. INDICATOR INSTALLATION
5.1. Unpacking and Installation
A. Take the indicator out of the packaging.
B. Connect the indicator and the platform and place the set on a flat and
even surface. Keep it far away from any sources of heat.
C. To level the weighing instrument turn its feet. Keep turning the feet until
the air bubble takes central position: