RADWAG PUE H315

17
0.4.3.
Cor
-
Entering correction values for linearity.
0.5.
Adnn
Additional modules activation
0.5.1.
UFA
YES, no
Wireless communication module: YES
- enabled, no - disabled.
0.5.2.
I_O
YES, no
IN/OUT module:YES - enabled, no -
disabled.
0.5.3.
rS3
YES, no
RS485 module: YES - enabled, no -
disabled.
0.5.4.
EtH
YES, no
Ethernet module: YES - enabled, no -
disabled.
0.5.5.
CL
YES, no
4-20mA moduleYES - enabled, no -
disabled.
0.6.
Boot
Bootloader
0.7.
dFLt
-
Default settings.
8.3. Device Defining
Defining the device at the production stage requires entering basic
balance/scale parameters: serial number, weighing device type, weighing
range.
Procedure:
 Enter factory setup <P0.FAct>.
 Go to <0.1.Glob / 0.1.1.duu> submenu, text <Cont?> is displayed.
 Press key, text <nr FAc> is displayed, next you see window
for entering the serial number.
 Enter the serial number, do it using the operation panel.
 Press key to confirm, text <type> is displayed, next you see window
for balance/scale type selection.
 Select balance/scale type, do it using operation panel (refer to factory
parameters table, section 8.2 of this manual).
 Press key to confirm, weighing range window is displayed.
 Select appropriate weighing range, do it using the operation panel.
 Press key to confirm, <0.1.1duu> submenu is displayed.
 Exit to home screen, to do it press key repeatedly.