RADWAG R Series

- 88 -
Response format:
1 2 3 4-12 13 14 15 16 17 18 19
D H Space mass space unit space CR LF
Mass
- 9 characters with right justification
Unit
- 3 characters with left justification
Give value of max checkweighing threshold
Format: OUH CR LF
Response: UH_MASA CR LF - command carried out
Response format:
1 2 3 4-12 13 14 15 16 17 18 19
U H Space mass space unit space CR LF
Mass
- 9 characters with right justification
Unit
- 3 characters with left justification
Set mass value of a single item (only for PARTS COUNTING)
Format: SM_XXXXX CR LF, where: _ - space, XXXXX – mass format
Response options:
SM_OK CR LF
- command carried out
SM_I CR LF
- command understood but not
accessible at this moment (e.g. mode
other than PARTS COUNTING)
ES CR LF
- command not recognised (mass
format incorrect)
Set target mass value (e.g. for DOSING)
Format: TV_XXXXX CR LF, where: _ - space, XXXXX - mass format
Response options:
TV_OK CR LF
- command carried out
TV_I CR LF
- command understood but not
accessible at this moment (e.g. mode
other than DOSING)
ES CR LF
- command not recognised (mass
format incorrect)
Set reference mass value (e.g. for DEVIATIONS)
Format: RM_XXXXX CR LF, where: _ - space, XXXXX – mass format
Response options:
RM_OK CR LF
- command carried out
RM_I CR LF
- command understood but not
accessible at this moment (e.g. mode
other than DEVIATIONS)
ES CR LF
- command not recognised (mass
format incorrect)
Value release
Format: SS CR LF
Response options:
SS_OK CR LF
- command understood and in progress
Command’s function is similar to function of PRINT button located on an overlay,
Internal adjustment
Format: IC CR LF
Response options: