Radwin Transportation FiberinMotion - TBS Mounting on a Wall

FinMDeploymentGuide Release4.5.10 2‐13
TBSMounting SiteInstallation
2. PlacethisassemblyonthepolewhereyouwanttomounttheTBS.Onceitisinplace,
rotatethepoleclampasshown,thentightenbothbolts.
HoriztonalPole‐thick
1. Diameterlargerthan3:Usemetalbands(notsupplied),threadedthroughtheholesas
showninFigure 2‐26,orU‐bolts(notsupplied),fastenedusingtheholesasshownin
Figure 2‐27:
TBSmountingonawall
1. Fastenthestandoffstothebaseplateintheholeslabeled“V”or“H”,whicheverismore
convenient,asshown:
Figure2‐24:Mediumpole:R otateclamp Figure2‐25:Mediumpole:tightenbolts
Figure2‐26:UsingmetalbandsforalargepoleFigure2‐27:UsingU‐boltsforalargepole