Radwin Transportation FiberinMotion - TBS Mounting on a Vertical Pole

FinMDeploymentGuide Release4.5.10 2‐6
TBSMounting SiteInstallation
TBSMountingonaverticalpole
Allsizes
1. Fastenthestandoffstothebaseplateintheholeslabeled“V”asshown:
Figure2‐3:Fastenstandoffstobaseplate(forverticalpole)
2. PlacetheTBSasshownoverthestandoffs,andusingtheAllenscrewsandwashers,fasten
theTBStothebaseplate.
 
Figure2‐4:FastenTBStobaseplate(forverticalpole)
VerticalPole‐thin
1. Diameter3/4to11/2:Bef oreraisingtheTBSonthepole,positionthepoleclampasshown
inthefollowingtwofigures.Donotcompletelytightenthebolts: