Radwin Transportation FiberinMotion - Waterproofing

FinMDeploymentGuide Release4.5.10 2‐31
Waterproofing SiteInstallation
2. A ttachtheLPUtothewallusingwoodormasonryscrews(notincluded),viathe
holesasshowninFigure 2‐61.
3. Connecttheleftscrew(wherethegroundinglugwaslocated)toagroundsource.
4. Removethecableglands.
5. ThreadtheCAT‐5e/6cablesthroughthecableglands,andconnectthecablestothe
LPUasshowninFigure 2‐58.
6. TightenthecableglandsaroundtheCAT‐5e/6cablesasshowninFigure 2‐59.
7. RouteoneCAT‐5euptotheradio(viatheupperLPU),andtheothertotheIDUor
PoE.
8. RADWINrecommendsthatyouaddextrawaterproofingtotheconnections
(seeseeWaterproofingonpage 2‐31).
Figure2‐61:InstallinganLPUonawall
2.2.9Waterproofing
Protectallconnectionsbetweenanyoutdoordevicesandcablesfromrain,dust,moisture
andsaltaccordingtotheprocedurebelow:
1. UseahighqualitysealingmaterialsuchasScotch23Tape¾”wide,toensureIP‐67
compliantprotectionagainstwateranddust.
2. Cuttwopieceseach25cmlong,ofScotch23splicingtape.Removetheplastic
covertoexposethetackysideofthesealingtapeasshowninFigure 2‐62.