Radwin Transportation FiberinMotion - Grounding Procedures for RADWIN Products

FinMDeploymentGuide Release4.5.10 2‐34
Synchronization SiteInstallation
2.3.3Synchronization
ISU
GPS
2.4TrackSide‐CombinedAboveandBelow
GroundRoute
Synchronization
ISU
GPS
CombinedGPSandISUsynchronization
2.5On‐board
2.5.1Overview
TheFiberinMotionsolutionusessharkfinantennasforitsmobileunits,andrelieson
antennaorientationtodifferentiatetheradiostreamsenoughsoastoenableMIMO.
GeneralGuidelines
• Locatetheantennasontheroofofthelocomotive,ascloseaspossible tothe
front/backend.
• PlacetheTMUascloseaspossibletotheantennas.
Power
• UsethePoEtosupplypowertotheTMU
• UsethePoEortheSFPfiberconnectiontoprovideaserviceconnectiontothe
TMU.