Radwin Transportation FiberinMotion - Method of Operation; Using the Configurator Tool; Main Tab

FinMDeploymentGuide Release4.5.10 4‐2
MethodofOperation ConfiguringtheRadio Network
TheConfiguratortoolisanExcelfilethatconsistsoffivetabs:
Main: Providesanoverviewofthecontentsoftheproject,aswellasvariousbuttonsfrom
whichyoucanconfigurespecificdevices.SeeMainTab.
Project: Allowsyoutoentervariousproject‐wideparameters,suchasthefrequenciesand
bandwidthsused,synchronization,units’power,QoS,VLAN,andEthernetmode,
andmore.SeeProjectTab.
Line: AllowsyoutoentertheIPaddressesofthevariousdevicesandgatewaysused,VLAN
definitionsandmore.SeeLineTab.
Towers: AllowsyoutoentertheIPaddressesofthevariousTBSsintheprojectinadditionto
theirneighbors.SeeTowersTab.
Trains: AllowsyoutodefinetherailcarsthatwillbeintheprojectandtheirTMUs.SeeTrain
Tab.
4.3.1MethodofOperation
Briefly,workwiththeConfigurationfileasfollows:
• ChangewhatevervaluesneedtobechangedusingtheConfiguratorfile,
• ClickonRecalcalldata(ifneeded:seepage 4‐5),then
• Savethefile.
• Oncethefileissaved,applythevaluesusingeithertheConfigureUnitbutton(see
page 4‐4),ortheHBSBatchConfigurationbutton(page 4‐4).
TheConfiguratorfilewillconnectwiththeunits,andapplythechanges.
4.4UsingtheConfiguratorTool
ClickonthedesktopicontostarttheConfigurator.Thefilewillopen,andtheMaintabwill
appear.
4.4.1MainTab
TheMaintabisshowninFigure 4‐1: