Radwin Transportation FiberinMotion - Project Tab; Upper Table

FinMDeploymentGuide Release4.5.10 4‐5
ProjectTab ConfiguringtheRadioNetwork
insteadofjustoneatatime.Acommandlineinterfacewindowwillopen,and
theupdatestatusofeachunitwill beshown.
Changesforonlyonelinearedone,asdeterminedbythevalueinthe Line
window.
Recalcalldata:Afteryouhavemadechangestovariousparametersasdescribedthroughout
thischapter,beforeapplyingthemtoanyunits,clickthistore‐calculateall
otherparametersthatma yhavebeenaffectedbyyourchanges.Thisdoesnot
applyanychangestoanyunits.
LowerTable: Providesanoverviewoftheequipmentandlinesusedinthewholeproject.
4.4.2ProjectTab
TheProjecttabholdsgeneralconfigurationparametersthatapplyacrosstheproject.
UpperTable
TheuppertableoftheProjecttabisshowninFigure 4‐3: