Radwin Transportation FiberinMotion - Page 87

FinMDeploymentGuide Release4.5.10 4‐6
ProjectTab ConfiguringtheRadioNetwork

Figure4‐3:Configurator‐Projecttab,uppertable
Band: Clickthispull‐downmenutochoosethefrequencybandtobe
usedfortheproject.Onlythosebandsthatareinaccordance
withyourregulatoryenvironmentwillappear.
ChannelBandwidth: Clickthispull‐downmenutochoosethebandwidthtobeused
fo
rthisproject.ThefrequenciesusedintheTowertab(F1,F2,
F3,etc)willbethebasefrequencychoseninBand,withthe
bandwidthadded.
Notethatnotallfrequencybandsallowallbandwidthstobe
used.
Synchronization: Clickthispull‐downmenutochoosethetypeofsynchronization
usedinthispr
oject:
IntegratedGPS:UseaGPSunitintegratedintheTBS.Usedin
abovegroundscenarios.
GSU:UseanexternalGPSunit.Usedinabovegroundscenarios.
Notethatthisrequiresextrainstallationandconfigurationfor
theGSU.