Radwin Transportation FiberinMotion - Page 32

FinMDeploymentGuide Release4.5.10 2‐19
TBSAntennas SiteInstallation
1. Whenmountingonathinpole,positionthepoleclampasshowninthefollowingfigures:
2. Placethis“unit”onthepolewhereyouwanttomounttheantenna.Onceitisin
place,rotatethepoleclampasshown,thentightenbothbolts.
MediumPole
ThismethodisformountingtheTBSantennaonapoleofpipesize2to3.
3. Connectthepoleclamptotheradioholderwiththe8x90bolts,butdonottighten
theboltsalltheway‐tightenthemsothattheyarenotcloserthanadistance
equaltotheradiusofthepole.Youwillthenhaveone“unit”thatyoucantaketo
Figure2‐36:ConnectPoleClamptoRadio
Holder
Figure2‐37:Tightenbolts
Figure2‐38:RotateClampandtightenbolts Figure2‐39:MountingKitonthinpole