Radwin Transportation FiberinMotion - Page 55

FinMDeploymentGuide Release4.5.10 2‐42
TMUMounting SiteInstallation
9. Placeeachmountingslidewiththestoppingflaptowardstherearoftherack,and
usingthePhilipsscrewswiththeblackwashers,fastenthemountingslidestothe
cagenutsandtighten.

Figure2‐71:Placingandfasteningmountingslide
10.Oncebothmountingslidesarefastenedtightlyontherack,insertthedr aweras
follows:
a. Placetheframeworkarmsofthedrawerintothemountingslidescarefully.Make
suretheyarestraight.
b. Pushbackthedraweruntiltheframeworkarmstouchtheball‐bearinggrey
housing.
c. Whilepressingoutwardsonbothball‐bearinggreyhousings,pushthedrawerin
furtheruntilthefr
ameworkarmsengagetheball‐bearinghousings.
d. Furtherpushthedraweruntilthelockingleverstopsit.
e. Releasethelockinglevers,andpushthedrawerinalltheway,eventhroughsome
resistancetowardstheend.