MiniRAE 3000 User’s Guide
65
Op Mode
Under Monitor Setup is “Op Mode.”
Press [Y/+] to select.
You see two options (one is highlighted):
Hygiene
Search
The current mode is indicated by a dark circle within the circle in front
of either Hygiene or Search.
1. Select Hygiene or Search by pressing [N/-]. The highlighting
changes from one to the other each time you press [N/-].
2. Press [Y/+] to select that mode for the instrument.
3. Press [MODE] when you want to register your selection to
place the instrument in the selected mode.
4. Press [Y/+] to commit the change and exit to the Monitor Setup
screen, or press [N/-] to Undo (exit to the Monitor Setup screen
without changing the Mode).
Site ID
Enter an 8-digit alphanumeric/character Site ID in the programming
mode. This Site ID is included in the datalog report.
1. Press [Y/+] and the display shows the current site ID. Example:
“RAE00001.” Note that the left-most digit flashes to indicate it
is the selected one.
2. Press [Y/+] to step through all 26 letters (A to Z) and 10
numerals (0 to 9).
Note: The last four digits must be numerals.
3. Press [N/-] to advance to the next digit. The next digit to the
right flashes.
To Next Page
Loading...
