Rae MiniRAE 3000 - Exiting Programming Mode; Navigating Programming Mode Menus

Rae MiniRAE 3000

113 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

MiniRAE 3000 User’s Guide

63

Note: Dashed line indicates automatic progression.

Table of Contents

Table of Contents3
Standard Contents11
General Information11
Physical Description13
Specifications13
Replacing Alkaline Batteries16
Charging a Lithium-Ion Battery18
- Charging a Spare Battery20
- Low Voltage Warning20
- Clock Battery21
- Data Protection While Power Is off21
User Interface22
- Display24
Operating the Instrument25
- Turning the Instrument on (Simple)25
- Turning the Instrument on (Power on Zero)26
- Turning the Instrument off26
- Operating the Built-In Flashlight26
- Pump Status27
- Calibration Status28
Operating Modes29
Compound-Specific Operation33
- Compound-Specific Measurement33
- Measurement Phases33
- Performing a Measurement33
- Separation Tube Preparation34
- Inserting the Separation Tube36
- Measuring37
VOC Operation40
- Basic User Level/Hygiene Mode (Default Settings)40
Alarm Signals43
- Alarm Signal Summary44
- Preset Alarm Limits & Calibration45
- Testing the Alarm45
Integrated Sampling Pump45
Backlight46
- Datalogging46
- Datalogging Event46
- Datalogging Sample46
- Auto/Manual/Snapshot Datalogging47
Accessories47
Standard Kit & Accessories48
- AC Adapter (Battery Charger)48
- External Filter49
Optional Accessories50
- Calibration Adapter50
- Calibration Regulator50
- Organic Vapor Zeroing Kit50
Standard Two-Point Calibration (Zero & Span)51
- Entering Calibration52
- Zero (Fresh Air) Calibration53
- Span Calibration54
- Exiting Two-Point Calibration in Basic User Level57
Three-Point Calibration58
- Span 2 Calibration60
- Exiting Three-Point Calibration61
Programming Mode62
- Entering Programming Mode62
Programming Mode Menus63
- Exiting Programming Mode65
- Navigating Programming Mode Menus65
- Calibration66
  - Zero Calibration66
  - Span Calibration66
- Measurement67
- Alarm Setting70
- Monitor Setup80
Humidity Compensation89
Hygiene Mode89
- Basic User Level & Hygiene Mode90
- Entering Search Mode from Hygiene Mode92
- Optional Graphic Screen in Search Mode93
Advanced User Level (Hygiene Mode or Search Mode)94
- Advanced User Level & Hygiene Mode94
- Basic User Level & Search Mode96
- Advanced User Level & Search Mode98
- Diagnostic Mode99
- Downloading the Datalog to a PC104
- Uploading Firmware to the Instrument from a PC105
Maintenance106
- Battery Charging & Replacement106
  - Replacing the Li-Ion Battery107
  - Replacing the Alkaline Battery Adapter107
- PID Sensor & Lamp Cleaning/Replacement109
- Cleaning the PID Sensor110
- Special Servicing Note113
Troubleshooting114
Technical Support115
RAE Systems Contacts116
Controlled Part of Manual119
Charging the Battery123

Other manuals for Rae MiniRAE 3000

Basic Operation/Pocket Reference40 pages

Related product manuals

Preview: Rae MiniRAE 2000

Rae MiniRAE 2000

Preview: Rae UltraRAE 3000

Rae UltraRAE 3000